You need to create a VLAN to support jumbo frames. Which commands would configure jumbo frame support on a VLAN?

A.	Switch# vlan 10
	Switch(config-vlan)# mtu 9128
B.	Switch(config)# vlan 10
	Switch(config-vlan)# mtu 9128
C.	Switch(config)# vlan 10
	Switch(config-vlan)# jumbo frames
D.	Switch(config)# vlan 10
	Switch(config-vlan)# mtu 1548

B. Configuration of jumbo frames requires creation of the VLAN from a global configuration prompt and then setting the maximum transmission unit (MTU). The value of the MTU will differ from switch to switch but is usually 9,000 bytes or higher.