In the following exhibit, which route statement will need to be added to the routers to allow routing between the networks?

A.	RouterA(config)#ip route 2001:db8:1000/64 serial 0/3/0
	RouterB(config)#ip route 2001:db8:2000/64 serial 0/3/0
B.	RouterA(config)#ip route 2001:db8:2000::/64 serial 0/3/0
	RouterB(config)#ip route 2001:db8:1000::/64 serial 0/3/0
C.	RouterA(config)#ipv6 route 2001:db8:2000::/64 serial 0/3/0
	RouterB(config)#ipv6 route 2001:db8:1000::/64 serial 0/3/0
D.	RouterA(config)#ipv6 route 2001:db8:2000::/64 2001:db8:1500::/64 eui-64
	RouterB(config)#ipv6 route 2001:db8:1000::/64 2001:db8:1500::/64 eui-64

C. You will need two route statements, one on each router. Each route should point to the far side network through the serial interface. Since the IP address is an IPv6 address, the easier way to configure the routes is to direct the packets to the exit interface of Serial 0/3/0.